Introduction:
JIC Fitting can be really a assortment of hydraulic fittings that’s produced in accordance with your SAE J514 standards. The acronym JIC stands for Joint Industry Council. It is also known as the JIC 37 degrees flare fitting because it’s a 37 degrees flare chairs surface. These fittings are used on oil hydraulic systems in many areas (fuel delivery, fuel power application, shipbuilding, mobile hydraulic equipment, etc.). . ) . A JIC matching www.kplokusa.com system contains three components which produce a tubing assembly: matching, flare nut, and also sleeve.
Material:
Materials used to fabricate JIC fittings include stainless steel and stainless steel SS316L.
JIC human body and flare nut are available in outer diameter (“OD) sizes between 1/8″ into 1 2″. Sleeve size is available from 3mm to 50mm and 1/8″ to two”. Fitting sizes are designated by the corresponding outside width of the tube for the many sorts of tube endings.
The normal working pressure of these fittings ranges from 1000 to 5000 psi for various sizes and relations. The minimum burst pressure is four times the working pressure. The JIC fittings should be able to withstand twice the working pressure for a time of 1 minute without failure or leakage.
Please take note the pressure evaluation of exactly the same fitting could vary if it is connected to different fittings. . By way of instance, if your matching with a minimal working pressure is connected to a pipe, then it is going to lead to an overall decrease working pressure. In all instances, always consider the smallest pressure since the maximum working pressure of the system.
How does a JIC matching works:
For tubing connections, the assembly procedure starts from the groundwork of this tube. To begin with, the nut and sleeve are inserted onto the end of tube. With the usage of a flaring tool, form the end of the tube to 37 degrees. Next, tighten the nut making use of a spanner until the nut is tight and the sleeve grips onto the tube. If the fittings are bench assembled, the grasping actions can be determined by rotating the tube by hand because the nut is slowly pulled down. When the tube can no longer be rotated yourself, the sleeve has gripped on the tube. While this occurs,, tighten the nut from turning it one full turn. This may vary slightly with different tubing materials, however for overall exercise, it is a fantastic rule to followalong with
Commonly used connection https://www.kplokusa.com types consist of: JIC/BSPP Male Connector, JIC/ NPT Male connector, JIC marriage, JIC/NPT Swivel Male Connector, JIC/BSPP Swivel Male Connector.
Make New JIC Fittings:
HS Corporation is a Korean maker Devoted to JIC Fitting. Launched in 1980, HS Corporation has over 30 decades of specialized experience in fabricating fittings.